To make the card wrap:
- Take a piece of vellum (1.5 inch x 11 inches) and rub an embossing bag over it. (Embossing buddy, talcum powder or a rosin bag to keep the static down so the stray powder doesn't stick to the outside of the stamping.
- Taking the MISTI lay the vellum in it and arrange the stamps with the part you stamp with facing down.
- Close the lid to pick up the stamps on the MISTI door
- Open the lid
- Ink the stamps with VersaMark
- Close the lid and stamp the image by pressing down on the lid over the stamps to make contact with the paper with your stamp.
- Open the lid, tilt the MISTI so you can see your stamped image, make sure it is completely stamped, if not just re-ink and re-stamp.
- Take the strip out and sprinkle with silver embossing powder
- Heat with heat gun
- Place the strip back in the MISTI with half the strip sticking out of the door.
- Peel the stamp off the door and rearrange on the strip to overlap the previous chain a little bit
- Close the door to pick up stamp
- Open door and ink, close door, stamp, remove powder, heat
- Repeat for other side
- Now your strip is finished.
- Take your trimmer and trim the extra vellum off the sides so the wrap is the thickness you would like
- Make your card (see my blog for more info on how to make my Halloween card)
- Take your card and wrap your wrap around the card and turn it over, overlap the strips and then tape it shut.
- Don't tape it tight, you want some play room to get the card in and out without bending the card.
I hope you got some good ideas from today's post! Happy Crafting!
No comments:
Post a Comment